PAYMENT METHODS
Accepted Payment Methods
Like Us On Facebook For All Our Latest News and Updates!
Newsletter

Little Bee Spring 40A ESC with BLHeli_S, DSHOT (2-6S)

With all the great features of the 20A Little Bees, this 40A variant gives you the headroom needed for powerful 6" 6S setups. They also run the new BLHeli_S firmware for smoother throttle response and support DSHOT!
Availability: Out of stock
£11.24

Overview:

The all new BLHeli_S Spring Bee versions of the popular Little Bee ESCs deliving a "smooth as silk" throttle response and support for DSHOT. With all the great features of the  20A Little Bees, this 40A variant gives you the headroom needed for powerful 6" 6S setups. These ESCs now supprt up to 6S LiPos and are capable of handling 40A current with up to 10s 45A bursts.

Don't forget - these ESCs have no BEC so you will still need a 5V power source for your flight controller, receiver, etc. Have a look at the related items below for suitable a suitable PDB and BEC. You may also need wire and bullet connectors unless you intend to solder your motors direct to the ESCs.

Features:

- Hardware PWM - smoother and more responsive motor response
- Solder Pads for motor wires

- Pre-Flashed with BLHeli_S Firmware
- Supports DSHOT

- Oneshot125, Onshot42, Multishot also available - Faster communication between flight controller
- Damped Light Always Enabled
- 2-6S support with 40A continuous load and 45A peak (10 seconds)
- Bootloader Enabled - you can flash new firmware and configure settings via USB using the servo cable (requires USB linker)

 

Specifications:

- Input Voltage: 2-6S Li-Po Battery
- BEC Output: OPTO (you need to power up your flight controller using an UBEC)
- Continuous Current: 40A (Burst Current: 45A for 10s)
- Size: 35 x 17mm
- Weight: ~12g (including wires)
- Battery wire length: ~90mm (may vary from time to time)
- Firmware: BLHeli_S With DSHOT Support
- Main IC: SILABS EFM8BB21F16, MCU running at 48MHz
- MOS: ALL N FET

Warranty Exclusion: Please note we can't provide any warranty on escs once soldered. Please test your escs in a non destructive manner BEFORE soldering them onto your quad. Removing the motor wires and soldering directly is in our experience risky - many escs get damaged in this way.

Customers who bought this item also bought

HobbyRC Rubberised Battery Strap 250x20mm

The HobbyRC battery strap is just the right length for most mini quad batteries while the rubberised reverse grips your battery and helps to stop it sliding back and forth in flight.
£0.39

DYS STORM 2207 2550KV Racing Edition 3-6S Brushless Motor

Introducing the DYS Storm Racing Edition motors.
£15.14

DAL T5040 V2 Tri-Blade Super Durable Propellers (2x CW + 2x CCW) - Crystal Blue

Perfect for your 250 sized mini racing drone, these Tri-Blade Props will change your flying forever. Small but powerful 5040 Tri-Blade Props will give you smooth, quiet flight while providing pure thrust punch outs.
£2.40