PAYMENT METHODS
Accepted Payment Methods
Like Us On Facebook For All Our Latest News and Updates!
Newsletter

Lumenier 4Power + Plus PDB (5v/10v Reg, 184A Curr.)

The Lumenier 4Power + Plus PDB with Dual BEC 5v 1.5A, 10v 1.5A, and 184A Current Sensor. (3-6s).
Availability: Out of stock
£10.72

Overview:

The Lumenier 4Power + Plus PDB is a feature rich power distribution board designed for small quadcopters. The board uses the standard 30.5mm mounting hole pattern (common to most flight controllers) to easily fit up to most airframes. This PDB features an easy to solder layout keeping builds clean and simple. The 4Power + Plus has all your power needs in one place with an onboard 5v and 10v BEC as well as a 184A capable Current Sensor. It can support from 3-6s LiPo battery and includes a lay-flat XT60 plug for low profile builds. Alternatively, you can simply solder power wires directly to the PDB and use a cable tie to secure it in place, reducing stress on the solder point. Each voltage regulator can supply up to 2A of current, allowing them to easily power your VTX, camera, FC, and some LEDs.

Features
- Input voltage range (3S-6S operation): 8 - 26VDC
- PDB: 4x30A (Max.4x46A)
- Regulated 5V (1.5A) and 10V (1.5A) outputs
- Current Sensor 184A

Specifications:

- 36mm square PDB with 32mm mounting holes (1.75mm thick)
- 2oz copper traces to support high amperage (2-4s)

PDB (ESC outputs)
Continuous current: 30A per output Peak current (10 seconds/minute): 46A Max per output

BEC 5V outputs

Designed for RC Receivers, Flight controllers, OSD, and Servos.
DC/DC synchronous buck regulator.
Voltage: 5.0 +/- 0.1VDC
Continuous current: 1.5 Amps (Max.2A 10s/minute)
Output Ripple: 40mV (VIn=16V, VOut=5V@2A load)
Short-circuit tolerant (5 seconds/minute)

BEC 10V outputs
Linear regulator, very low noise. LC Filter is needless.
Designed for Video TX or FPV camera.
Stable power output even on low voltage 3s (below 12v)
Voltage: 10.0V +/- 0.3VDC (4~5S operation)
Continuous current: 1.5A@16V IN (2A Max)
Short-circuit tolerant (2 seconds/minute)

Current Sensor

184A / 3300mV

Included:

- 1x Lumenier 4Power + Plus PDB
- 1x Lay-Flat XT60 power connector
- 1x Set of Nylon standoffs
  - 4x M3 6mm hex standoff
  - 4x M3x12mm screws
  - 4x M3 hex nuts

 

NOTE: Pololu voltage regulator module not included

Customers who bought this item also bought

HobbyRC Rubberised Battery Strap 250x20mm

The HobbyRC battery strap is just the right length for most mini quad batteries while the rubberised reverse grips your battery and helps to stop it sliding back and forth in flight.
£0.39

TBS Bulletproof 25A (BLHELI-S)

The next generation 25A bulletproof ESC from Team Blacksheep.
£16.90

Lumenier Small Battery Strap

The Lumenier branded small Lipo Battery Strap made by Scorpion.
£2.28