Accepted Payment Methods
Like Us On Facebook For All Our Latest News and Updates!

Lumenier Skitzo RaceFlight Revolt F4 Flight Controller

The Lumenier SKITZO Flight Controller is an advanced FC with a F4 MPU and powered by RaceFlight. Based on the Revolt FC, inspired by SKITZO.
Availability: In stock


The Lumenier SKITZO Flight Controller Powered by RaceFlight is the most advanced, performance driven, flight controller ever designed. The SKITZO Flight Controller was created in collaboration with and named after the flow master himself SKITZO FPV. Capable of running 32kHz gyro sample rate, PID loop, motor loop and processing all calculations in real time. The SKITZO FC is powered by the same hardware as the new RaceFlight Revolt which has incredible performance. The Lumenier SKITZO Flight Controller uses a F405 MPU and a Invensense 20602 gyro in combination with RaceFlight software to give you the BEST performance possible. This gyro is by far the most noise free and accurate gyro available.


This flight controller comes pre-loaded with the latest RaceFlight Community release. Just go to the google store and download the latest configurator, and you should be ready to connect. Drivers should no longer be needed.

RaceFlight One is also available in alpha format. Just join the slack at and ask to be added to the RaceFlight One channel. This is truly amazing software, which flies so well you can completely eliminate prop wash. Setup is a breeze as well, just run a couple wizards and you will get right up into the air.

Setup Simplicity:

Setting up the Lumenier SKITZO Flight Controller is easy. The solder pin layout is easy to read with motor connections in each corner. Just solder the closest motors and remember the order 1, 2, 3, 4. Select your voltage on the bottom, as well as inverted or not. The SKITZO FC also features DFU free updating and a self-healing and updating bootloader, just in case something does go wrong.


- Supports the new RF1 firmware
- Integrated vibration dampening dummies
- Custom SKITZO color and silk screen
- Dual inverters for taranis and futaba radios
- True hardware radio diversity
- Selectable voltage for your UARTs
- LED Driver for WS2812b programmable LED
- Infrared LED Race Transponder support – no need for separate transponder
- Future iPhone and Android configurator support
- High Speed 32khz gyro, lowest noise floor and highest sensitivity gyro ever used
- Through hole solder pads – forms an I-Beam when soldered for extra strength
- FrSky Taranis, Spektrum, Futaba, JR, IBus, Sbus and other radio support
- Integrated buzzer driver
- Voltage and current ADC pins, for full voltage and current monitoring
- Full telemetry output support
- ESC flashing and configuration built into configurator
- Most active software development
- Selectable 3.3v or 5v voltage
- 4 serial uarts
- Bluetooth expandable
- F4 processor
- 16mb of flash memory
- GPS expandable
- Dimensions: 36mm x 36mm
- Mounting holes: 30.5mm squared to center of holes


- 1x Lumenier Skitzo Flight Controller
- 4x Rubber Mounting Grommets

PLEASE NOTE: We cannot accept any returns after the board has been soldered/modified. Please test the board (via USB) BEFORE soldering the header pins on.