Accepted Payment Methods
Like Us On Facebook For All Our Latest News and Updates!

MinimOSD OSD For Naze 32 With MultiWii OSD & KV Team Mod (Pre-Soldered)

This Board can be used just as a normal OSD for APM or it can be used with MWC KV Team Mod or the newer Multi Wii OSD.
Availability: Out of stock


The MinimOSD comes pre-programmed with Multi Wii OSD.It differs from alot of the other minimosd clones on the market by having additional input pins to allow information such as battery voltage and RSSI data to be displayed directly on the OSD (See below). It's main components are an ATmega328P 8 bit microcontroller with an Arduino bootloader, and a MAX7456 monochrome on-screen display. Programming is done through an FTDI cable using the arduino software. By re-programming the OSD can also be used for the APM flight controller or CC3D.

The KV Team Mods allows for direct monitoring of battery voltages via 8 additional pins ( BAT1, GND, BAT2, GND, RSSI, GND, VIOUT, GND). The BAT pins already have voltage dividers and can read upto 4s directly.  VIOUT (Current Sensor Input) & RSSI support up to max 5v input. With supported firmware you can have this additional information appear directly on the OSD.

To program/configure this board you will need to buy an FTDI cable and download the mwosd software, the minimosd won't function properly without this. 


- ATmega328P with Arduino bootloader
- MAX7456 monochrome on-screen display
- FTDI cable compatible pinout
- Standard 6-pin ISP header
- Two independent power sections with an LED indicator on each
- Solder jumpers for combining the power sections
- +5V 500mA regulator for up to +12V supply input
- Solder jumper for PAL video option
- Exposed test points for HSYNC and LOS
- Dimensions: 0.7"W x 1.7"L (2.4" w/ pins as shown) x 0.3"H


PLEASE NOTE: MinimOSDs are very easy to destroy by incorrectly connecting your camera or voltage feeds. Please be very careful when connecting everything up as we cannot honour the warranty for units damaged by incorrect wiring/over voltage. Take careful not of the included instructions and if you are ever in doubt of how to wire anything, please ask us.


Customers who bought this item also bought

USB 5V FTDI CP2102 Serial Adapter

A tiny 5V FTDI breakout board for USB - Serial applications. Needed for programming Arduino boards.

HobbyRC Rubberised Battery Strap 250x20mm

The HobbyRC battery strap is just the right length for most mini quad batteries while the rubberised reverse grips your battery and helps to stop it sliding back and forth in flight.

4pcs 110mm DuPont Single Pin to Pin (1P) Connector Wire

A handy connector for use in many applications when wiring multirotors including GPS modules, OSDs, flight controllers and more.