Matek F722 Mini SE Flight Controller

The Matek F722 Mini SE features an MPU6000 gyro, Black Box memory, VTX control and dual camera input.
Availability: Out of stock
£40.45 inc VAT
Ship to
Shipping Method
Estimated Delivery
No shipping options


The Matek F722 Mini SE is the latest 20x20mm flight controller from Matek, but also comes with a 30.5mm mounting board so can be used on full sized quads too.

The Matek F722 Mini features an MPU6000 gyro, Black Box memory, VTX true on/off filtered power switching and dual camera inputs (switchable). The flight controller also supports both Betaflight & INAV firmware.


- MCU: 216MHz STM32F722RET6
- IMU: MPU6000 (SPI)
- OSD: AT7456E (SPI)
- Baro: Infineon DPS310 (I2C)
- Blackbox: 32M-byte Flash memory (SPI)
- 5x Uarts (1,2,3,4,6) with build-in inversion
- 1x Softserial supported
- 8x Dshot/Proshot/oneshot outputs
- 1x I2C
- 1x SH1.0_8pin connector (Vbat/G/Curr/R6/S1/S2/S3/S4)
- 3x LEDs for FC STATUS (Blue, Green) and 3.3V indicator(Red)
- Vbat filtered output power for VTX, Switchable via AUX (modes tab-user1)
- Dual Camera image switchable via AUX (modes tab-user2)
- Convertible 20mm to 30.5mm mounting
- Camera control: Yes
- Smartaudio & Tramp VTX protocol: Yes
- DJI OSD: Yes (any spare Uart Tx & Rx)
- WS2812 Led Strip : Yes
- Beeper : Yes
- RSSI: Yes
- Additional ADC for INAV analog airspeed

FC Firmware
- INAV target: MATEKF722mini

- BetaFlight unified target: MATEKF722mini(MTKS)
- BetaFlight legacy target: MATEKF722SE

- Input: 6~36V (2~8S LiPo)

- BEC: 5V 2A
- LDO 3.3V: Max.200mA
- Battery Voltage Sensor: 1:10 (Scale 110)
- No Current Sensor built-in, supports external current sensor of PDB/4in1

- 20 x 20mm/Φ3mm with Silicon Grommets
- 20 x 20mm/Φ2mm with Silicon & Brass Grommets
- 30.5 x 30.5mm/Φ3mm with Conversion Plate and Silicon Grommets
- Dimensions: 28 x 28 mm
- Weight: 5g

- 1x FC F722-miniSE

- 1x 20mm to 30.5mm conversion plate
- 6x Silicon grommets M4 to M3
- 6x Brass grommets M3 to M2
- 1x SH1.0_8pin cable 5cm
- 2x SH1.0_8pin connectors