Mode-2 Shredder II 5" FPV Frame
The new Shredder II from Mode 2 is finally here and features tons of radical improvements over the original. This is the 5" version.
Availability: Out of stock
The new Shredder II from Mode 2 is finally here and features tons of radical improvements over the original, and we didn’t use any secret ooze to get the job done. The Mode 2 Shredder II is a robust symmetrical X quadcopter frame that is as light as possible without sacrificing rigidity and strength. This is the 5" version.
The Shredder is a totally tubular multipurpose frame built for racing, freestyle, and long range if you’re flying the 7″ or 10″. You can probably even fly it through the sewers, though we don’t recommend you do.
The Shredder II features a gnarly interlocking arm system which will ensure the arms stay in place at all times. The 5″ variant comes with 4mm thick arms.
We’ve also included four 25mm stack bolts for your flight controller and electronics. Also featured in the rear of the frame is a 20×20 stack section for your TBS CRSF/Unify Nanos, or other similar hardware, allowing for a more streamlined and low-profile build. You can also top or bottom mount your battery according to your preferences.
Get one soon and start shredding!
**PLEASE NOTE: 3D Printed Parts are Black, not green as per the image **
WARNING: DO NOT BUILD WITH PRESS NUTS FACING DOWN, BUILD WITH PRESS NUTS FACING UP!
240mm Symmetrical X (5")
Flight Controller: 30.5×30.5mm; 20x20mm
Rear Accessory: 20x20mm
3mm Chamfered Top Plate
3mm Chamfered Bottom Plate
4mm Chamfered Arms (5")
4-6mm Locking Tab
Stainless Steel Fasteners (x17) 8mm (5" / 7")
Stainless Steel Fasteners (x4) 25mm
Stainless Steel Washer 1mm (x9) M3
Stainless Steel Low Profile Nut (x4) M3
Female to Female Nylon Stack Riser (x4)
Aluminium Standoffs (x4) 25mm Gunmetal
TPU Micro Camera Mount (Black)
TPU Antenna/Axii Mount
5" – 115g
The supplied stack hardware adds an additional 7g