Name: A to Z
Name: Z to A
Price: Low to High
Price: High to Low
A 100mm servo cable, perfect for connecting your receiver to your flight controller.
A simple voltage monitor to take advantage of the FS-iA6B receiver's telemetry capabilities.
This is a fantastic receiver for FlySky transmitters - it improves on the older FS-iA6 model by adding telemetry capability and PPM output.
The D4R-II is one of the most affordable and advanced telemetry capable receivers. Paired with a Naze32 flight control board, this receiver takes your multi-rotor to the next level.
Measure the current draw up to 40 amps in real time with this current sensor. Compatible with all SMARTPort enabled receivers.
This is a new sensor designed and developed by FrSKY to collect important flight information and performance data which can then be transmitted via the SMART PORT of telemetry-enabled receivers such as X8R, X6R, X4R, etc to a Taranis Transmitter.
The FrUSB-3 USB cable connects to the transmitter module, Sensor Hub and 8 channel telemetry receivers to allow firmware updates. USB→UART, RS232 level.
The L9R receiver (9/12CH non-telemetry long range receiver). Extend your range of your FrSky 2.4GHz system with this L9R long range receiver. This receiver will give you up to 3x the range of a standard V8 or D series and 2x the range of X series.
One 150mm FrSky amplified PCB receiver antenna - suitable for any FrSky 2.4GHz receiver with 'snap on' u.FL/IPX connector (X4R, X8R, etc.). Increases the range of your FrSky radio system by up to 25%
One standard 150mm FrSky receiver antenna - suitable for any FrSky 2.4GHz receiver with 'snap on' u.FL/IPX connector (X4R, X8R, etc.).
One standard 150mm FrSky receiver antenna - suitable for newer X4R receivers.
Converts the SBUS signal into CPPM without the need for any soldering. Simply plug into your SBUS receiver port and your control servo and it will decode the SBUS signal to CPPM.
The FrSky Variometer sensor calculates the altitude from atmospheric pressure. Atmospheric pressure will get lower as you go up in altitude, using this the sensor will estimate the altitude.
FrSky's X4R-SB receiver features 3 PWM outputs (normal servo), SBUS port that carries all 16 channels and CPPM output.
FrSky's X6R receiver features 16 channels (6 normal PWM outputs and all 16 channels on the dedicated SBUS output). Plus the exciting new Smart Port and a traditional A2 port on the bottom.
FrSky's newest receiver features 16 channels (8 normal pwm outputs and all 16 channels on the dedicated Sbus output). Plus the exciting new Smart Port.