Hobbywing XRotor Micro 40A 6S BLHeli_32 4in1 ESC (20mm)
The Hobbywing XRotor Micro 40A (20x20mm) 6S 4in1 40A ESC features a 32bit MCU and runs 3rd Generation BLHeli-32 firmware.
Availability: Out of stock
The Hobbywing XRotor Micro 40A (20x20mm) 6S 4in1 40A ESC features a 32bit MCU and runs 3rd Generation BLHeli-32 firmware. The 4in1 can handle 6S voltages and upto 40A per channel. The 4in1 ESC features a built in voltage and current sensor.
** The power wire + capacitor comes pre-soldered on this board **
High Quality Hardware
High performance 32bit ARM MCU can run at 48MHz. 3in1 IC drive, imported Mosfets and ceramic capacitors. 3 ounce copper, 8 layer PCB.
The soft mounts prevent vibrations from being transferred to the FC.
DSHOT 1200 Ready
Besides the regular PWM Mode, Oneshot125/Oneshot42/Multishot and DShot150/300/600 modes, DShot 1200 is supported which provides greater anti interference and rapid response.
Hardware Generated PWM & Damped Light Mode
The ESC firmware uses hardware generated motor pwm for smooth throttle response and silent operation. Damped light does regenerative breaking, causing very fast motor retardation, and it inherently also does active freewheeling.
- XRotor Micro 40A 4in1 ESC BLHeli32 DShot1200 6S
- Continuous/Peak Current: 40Ax4/60Ax4
- Size: 20x20mm mounting
- Lipo Cells: 3-6S
- Bec Output: No
- Input Wires: Red-14AWG-100mm / Black-14AWG-100mm
- Firmware: BLHeli32
- Dimensions: 40x33x5mm
- Weight: 12g
- 1x XRotor Micro 40A BLHeli32 4in1 ESC (20x20mm mounting holes)
- Capacitor (pre-soldered with power wires - no connector soldered on)
- Cables (JST + input wires)
- XT60 connector